Bifilar coil And Radiant energy
- CGD TAO
- Energy
- 21/12/2021
Bifilar coil
The solenoid coil, which is a Bifilar coil, contains two parallel coils spaced close to each other. Technique: consists of two strands or ropes entering the center, and then coming out again. The figure below depicts exactly:
This Bifilar winding is commonly used to refer to a special type of winding for transformers. Wires can be purchased in a bidirectional format. Usually, enamel wires of different colors are glued together. For three strands, the same term triple reel is used.
Series-connected parallel wound Bifilar coil, Nikola Tesla patented a way (512,340). Thus, the capacitance between the parallel windings is charged by the increased potential difference (1/2 of the supply voltage) between the windings in series.
This allows the coil to hold a significantly increased amount of energy in its electric field. This will greatly reduce the resonant frequency of the coil.
Some biofilters have adjacent coils, where the coils are arranged so that the potential difference is widened (that is, current flows in the same direction in parallel). Others are wound so that the current flows in the opposite direction. Thus, the magnetic field produced by one coil is equal to and opposite to that produced by the other coil, and the net magnetic field is zero (that is, neutralizing the negative effects of the coil)... electrically, this means that the coil has zero inductance.
Bifilar coils are used in modern electrical engineering as a means of constructing coil resistors of negligible parasitic inductance.
The electromotive force counter to suppress, switch to power supply mode part of the relay coil is used, and the transformer is being used another type of similar winding. In this case, the two windings are placed close together and wound in parallel, but electrically isolated from each other. The primary coil is driven to operate the relay and the secondary coil is short-circuited in case. When the current flowing through the primary is cut off, such as when a relay trip, most of the magnetic energy is cut off by the secondary coil and the secondary is converted to heat. With its internal resistance. This is just one of several ways to absorb energy from the primary coil before damaging the relay driver (usually a fragile semiconductor). The main limitation of this method is that it greatly increases the switching time of the relay.
Radiant energy
The electrical, radiant energy throughout the universe, which Tesla referred to and would use to provide power wirelessly of all the inventions and discoveries of Nikola Tesla, stood out with greater potential benefit to the whole of humanity and his discovery of Radiant Energy. Only after conducting exhaustive experimental trials for three years, did Tesla announce this discovery in a paper published in December, 1892, entitled "The Dissipation of Electricity" .
Radiant Energy is always there in our atmosphere. Radiant energy includes solar radiation from the sun, as well as cosmic rays from the stars. New and varied free energy devices harness this power to produce electricity
Electronic Circuit for Radiant Energy: Radiant Energy with Bifilar coil - Impulse Technology
Electronic equipment required for radiant energy: Electronic components for Radiant Energy - Impulse Technology
Tesla gives various options for the switching device. One is a rotary switch that resembles a Tesla circuit controller. Another is an electrostatic device consisting of two very light, membranous conductors suspended in a vacuum. These sense the energy build-up in the capacitor, one going positive, the other negative, and, at a certain charge level, are attracted, touch, and thus fire the capacitor. Tesla also mentions another switching device consisting of a minute air gap or weak dielectric film which breaks down suddenly when a certain potential is reached.
